Skip to content

Magnetic Nanoparticle Synthesis Freelancer for Heavy-Metal Water Treatment

The client wants a magnetic nanoparticle synthesis freelancer to make spinel particles that pull heavy metals out of water and can be recovered with a magnet. This brief covers the synthesis route, particle size and the magnetic separation test.

  • Open · checked 12 Nov 2026
  • Chemical Engineering
Budget$3,000–5,000 USD
TimelineNot stated
Skills asked4
Posted1 week ago

Is the budget fair? A $3,000–5,000 budget looks workable for a small set of synthesis runs and basic characterization. It looks tight if the client also expects extensive heavy-metal testing and repeat batches.

What the client needs

  • Synthesize phase-pure spinel nanoparticles by a reproducible wet-chemistry route.
  • Keep particles reasonably uniform in size, ideally 30 nm or less.
  • Show the particles separate from a sample within seconds under a handheld magnet.
  • Test their ability to capture lead, arsenic and chromium from water.

Skills the client asked for: Chemical Engineering, Nanotechnology, Environmental Engineering, Materials Science.

Where to aim your bid

Low$3,300
Sweet spot$3,800
High$4,400

The sweet spot sits about 40% of the way up the client's range, the same rule AutoBidPilot uses for its own price suggestions. Go higher when the scope is large or unclear; go lower only when you can show close, finished work. Check what you keep after fees with the bid price calculator.

What the project involves

The client needs a nanotechnology specialist to reliably synthesise MnFe2O4 nanoparticles with strong magnetism, suited to magnetic separation in wastewater treatment. The aim is to test how well they capture lead, arsenic and chromium from contaminated water and then recover them quickly and cleanly with an external magnet.

Synthesis requirements

Co-precipitation, hydrothermal, solvothermal or another reproducible wet-chemistry route is acceptable. The particles must be phase-pure spinel, reasonably monodisperse (30 nm or smaller preferred) and magnetic enough to separate from a 50 mL sample within seconds under a handheld neodymium magnet.

Deliverables

  • 5 g of dry MnFe2O4 nanopowder, vacuum-sealed and labelled
  • A concise synthesis protocol with reagent grades, concentrations, times and temperatures
  • A characterisation report: TEM or SEM for size and morphology, XRD for phase, VSM or SQUID for saturation magnetisation, and ICP-OES or EDS for elemental ratios
  • Brief test data showing removal efficiency for at least one batch against Pb2+, As5+ or Cr6+ at ppm levels, plus recovery time under a magnetic field

Acceptance criteria and application

  • Saturation magnetisation of at least 90 emu per gram at room temperature
  • At least 80 percent removal of one listed heavy metal within 30 minutes of contact
  • Applicants should confirm synthesis facilities, typical turnaround and prior experience with ferrite or magnetic oxide nanomaterials

How to win this project

  1. Describe your synthesis route and how you would show it can be repeated batch to batch.
  2. Share characterization data from a past nanoparticle batch, such as particle size and magnetic response.
  3. Ask how many test runs and samples the client expects, and what counts as a pass.

Questions to ask the client

A specific question in your first message shows you read the brief. Pick one or two:

  • Which route do you prefer: co-precipitation, hydrothermal or solvothermal?
  • What characterization is required, and does the client need the data as a report?
  • What quantity of particles is needed, and will you deliver the test results too?

Common questions

How much does a magnetic nanoparticle synthesis freelancer cost?

The posted budget is $3,000–5,000 USD. The price depends on the number of synthesis runs, characterization and whether heavy-metal testing is included.

What skills does a magnetic nanoparticle synthesis freelancer need?

The client lists chemical engineering, nanotechnology, environmental engineering and materials science. Show past nanoparticle synthesis with size and magnetic data.

Is this project still open?

We checked this project on 10 November 2026. Projects get awarded, so apply soon; we take a brief down when it closes.

This page is our own summary of a project posted online, written to help you decide and to write a better bid. Projects get awarded or closed, so apply soon; we take a brief down when it closes. No job or income is guaranteed.

Before you apply

To apply for this job you need a free AutoBidPilot account. It takes about a minute:

  1. Create your account with your email, Google or GitHub.
  2. Verify your email. We send you a link; opening it brings you straight back to this job.
  3. Finish a short setup (your skills and pricing), then apply.
Create free account I already have an account

100 free credits when you connect your profile.